Tektronix AWG610 Portable Generator User Manual


 
The Graphical Waveform Editor
3-54
AWG610 Arbitrary Waveform Generator User Manual
4. Push the Point (or Time) side button. Use the general purpose knob or
numeric keys to specify the amount of shift. A positive value shifts data to
the right, and a negative value shifts data to the left.
5. Push the Exec side button to shift the part specified in step 3 by the amount
specified in step 4.
The Vertical Shift... command shifts the cursor-to-cursor waveform data up or
down the value specified with Value. If Value is positive, the data shifts up; if
Value is negative, the data shifts down. The editor retains values that exceed the
default ±1.0 waveform peak-to-peak range. You can use the Zoom or Pan
commands to view data that is out of the waveform display range. You can only
vertically shift waveform data; you cannot vertically shift marker data.
Do the following steps to vertically shift waveform data:
1. Move the cursors to specify the edit area to shift.
2. Push Operation (bottom)!Vertical Shift (pop-up)!OK (side).
3. Push the Value side button. Specify the amount of shift using the general
purpose knob or numeric buttons. A positive value shifts data up, and a
negative value shifts data down.
4. Push the Exec side button to shift the waveform by the amount you specified
in Step 3.
The Expand... command horizontally expands (scales) the edit area waveform
and marker data by a specified amount in the range of 2 to 100. Expansion starts
at the left cursor position. All data in the edit area expands as required for the
amount of expansion.
1. Move the cursors to specify the edit area to expand.
2. Push Operation (bottom)!Expand... (pop-up)!OK (side).
3. Push the By side button. Specify the amount of expansion by using the
general purpose knob or numeric buttons. You may specify any integer from
2 to 100.
4. Push the Exec side button to expand the edit area data starting at the left
cursor position.
The Vertical Scale... command vertically shrinks or expands the edit area
waveform data by a specified factor value, around a specified origin value. The
Factor value range is –100 to 100 in 0.01 increments. The Origin value range is
–1 to 1 in 0.0001 increments.
Vertical Shift...
Expand...
Vertical Scale...