Filter
Top Products
Appendix B: Performance Verification
B-36
AWG610 Arbitrary Waveform Generator User Manual
Sine Wave Tests
This procedure checks the sine wave characteristics of the AWG610 Arbitrary
Waveform Generator output waveforms.
Equipment
required
A 50ĂW SMAĂcoaxial cable, a DC block, aĂBNC(Fe)ĆN(Ma)Ăadapter,Ăa
SMA(Fe)ĆBNC(Ma)Ăadapter,Ăand a spectrum analyzer.
Prerequisites The AWG610 Arbitrary Waveform Generator must meet the
prerequisites listed on page B-8.
Do the following steps to install the test hookup and set the test equipment
controls:
1. Use the 50 W SMA coaxial cable, adapters, and DC Block to connect the
AWG610 Arbitrary Waveform Generator CH1 output connector to the input
connector on the spectrum analyzer (see Figure B–13).
AWG610 Arbitrary Waveform Generator
Spectrum Analyzer
50 W SMAĂcoaxial cable
InputĂconnector
+ĂBNC(Fe)ĆN(Ma)Ăadapter
+ĂDC Block
+ĂSMA(Fe)ĆBNC(Ma)Ăadapter
+50 W SMAĂcoaxial cable
Figure B-13: Sine wave initial test hookup
2. Set the spectrum analyzer controls as follows:
Center frequency . ................ 500MHz
Full Span . ...................... 1000 MHz
Reference level . .................. 10dBm
RF attenuation . .................. 30dB
Video filter . ..................... 1kHzĂ(orĂ3ĂkHz)
Resolution BW . .................. 1MHzĂ(orĂ3ĂMHz)