Filter
Top Products
The Graphical Waveform Editor
AWG610 Arbitrary Waveform Generator User Manual
3-59
You can also use the Maximum Length Setting side button to automatically
set the tap positions to maximize the length of the random waveform data
sequence.
5. Select Data, Marker1, or Marker2 in the Target field to specify the
waveform data type to replace with the register output.
6. If desired, enter the initial register bit pattern values in the register graphic
icon at the top of the dialog box.
You can also use the Set All Registers side menu to set all register bits to
one.
7. Push the OK side button to generate the cursor-to-cursor pseudo-random
pattern in the area specified in Target.
The Set Pattern... command replaces existing edit area waveform data with 0 or 1
data values that you specify. You can also use this command to copy the pattern
data from one editor window and replace it in another editor window. If the
pattern you enter has fewer data points than those in the edit area, the pattern
repeats until the end of the edit area. This command does not change the
waveform data record length. Selecting Set Pattern opens the Set Pattern dialog
box, shown in Figure 3–8.
Figure 3-8: Set Pattern dialog box
Table 3-12: Set Pattern dialog box parameters
Parameter Description
Total Points Displays the number of data points entered in the Pattern field.
The instrument updates this value as you change the pattern
data in the pattern field.
Cursor Position Displays the cursor position in the pattern field. The instrument
updates this value as you change the cursor position in the
Pattern field.
Set Pattern...