Filter
Top Products
Capturing Waveforms
3-172
AWG610 Arbitrary Waveform Generator User Manual
Procedures for Capturing Waveforms
Do the following steps to capture a waveform:
1. Set the GPIB parameters in the AWG610 Arbitrary Waveform Generator.
The AWG610 Arbitrary Waveform Generator must be set to the controller.
Refer to Connecting to a GPIB Network on page 3–153 for setting the GPIB
parameters.
2. Set the GPIB address and Talk/Listen mode in the source instrument.
3. Start acquisition in the source instrument.
Do the following steps to capture the waveform:
1. Push EDIT (front-panel)!Tools (bottom)!Capture Waveform (side).
The dialog box listing the instruments appears as shown in Figure 3–57.
Figure 3-57: Source instrument selection dialog box
a. If necessary, select Others... to open the other source instrument list.
The dialog box listing the instruments appears as shown in Figure 3–58.
b. Select a source instrument from the list.
c. Push the OK side button.