Filter
Top Products
File Management
3-216
AWG610 Arbitrary Waveform Generator User Manual
Delete removes the selected file. Delete All removes all files and empties
directories contained in the current directory. These commands do not delete any
directories that contain files. When you delete files or directories, the instrument
displays a dialog box asking you to confirm the file/directory deletion. Do the
following steps to delete one or more files and/or empty directories:
1. Select a file or directory to delete.
2. Push the Delete or Delete All side button.
3. Push OK or Cancel (side), depending on the message to confirm deletion.
To move a file between directories or drives, use the Move or Move All com-
mand in the double windows. Refer to Operation in Double Windows on
page 3–217.
Attribute prevents a file or directory from unconditional modifications or
deletion. This is made by assigning the Read Only or Read/Write attribute to the
file. After you assign the Read Only attribute to the file, a key mark appears on
the left of the file listing.
1. Select a file to which you want to assign or change an attribute status. All
files are assigned read/write status by default.
2. Push the Attribute side button to toggle between Read/Write and Read
Only, as necessary.
File Operation in Double Windows
When the Window bottom button is displayed, you can divide the file list in the
Edit Screen into two windows as shown in Figure 3–69. This function is called
Double Windows.
In the Double Windows, you can also perform drive and directory operations to
the currently selected window using the same procedures as those in Single
Windows. Refer to File Operations on page 3–214 for the procedures.
Deleting One or All Files
Moving Files
Assigning Attribute to
Files