Operating Basics
AWG610 Arbitrary Waveform Generator User Manual
2-33
2. If you have made no modifications to the data, the editor is immediately
exited. If you have not saved the data after modifications, the message box
Save the changes you made? appears. Push Yes, No, or Cancel side button.
Setup Overview
The Setup screen is where you load and set up the waveform for output. This
section gives you an overview of the Setup screen, how to load a file, how to set
the signal output parameters, and how to enable signal output. Refer to The Setup
Menu on page 3–29 in the Reference section for more information.
To display the main Setup screen, push the SETUP front-panel button. The
instrument displays the main Setup screen as shown in Figure 2–24. Table 2–12
describes the screen waveform parameter icons. Table 2–13 lists the bottom
menu functions.
Clock frequency Run mode Instrument status
Bottom menu
Side
menu
area
Waveform
parameter icons
Data record length of
active channel waveform
Figure 2-24: Main Setup screen
Main Setup Screen