Tektronix AWG610 Portable Generator User Manual


 
The UTILITY Window
AWG610 Arbitrary Waveform Generator User Manual
3-161
Set the FTP Server to enable you to enter into the hard disk or floppy disk file
system of the AWG610 Arbitrary Waveform Generator from a remote computer.
Type the following command on your computer keyboard:
ftp <IP address>
Press Return on the keyboard.
The AWG610 Arbitrary Waveform Generator prompts you to enter a login name
and password. Press the Return or Enter key on your keyboard. The message
‘User log in’
and the prompt
‘ftp>’
appears when you are successfully logged in.
At the prompt, you can use the commands as listed in Table 3–44. These are the
only available ftp commands for use with the instrument.
Table 3-44: Available FTP commands
Commands Descriptions
ascii Sets the file transfer mode to ascii.
binary Sets the file transfer mode to binary. Use this mode when you
transfer a file other than the text file.
bye Terminate the ftp session and exit the ftp.
cd xxxx Changes the current working directory on the instrument.
Specify a directory at xxxx.
To change the drive, specify /<driveĆname>/". For example, to
move into the floppy disk, type the following:
cd “/floppy/”
Type “/main/” for the hard disk drive and “/NET1/” for
remote file system NET1, and so on.
dir Lists all the files in the current directory in the instrument.
get xxxx [localĆfile] Receives the file xxxx in the instrument and stores it in the
local file. The xxxx name is used if the local file is not specified
hash Toggles the hashĆsign on and off. The hashĆsign is printed for
each data block transferred when the hashĆsign (#) is set to on.
ls Lists the all files in the current working directory in the
instrument.
FTP Link