Filter
Top Products
Quick Editing
3-96
AWG610 Arbitrary Waveform Generator User Manual
Setting Parameters
When changes are made to the waveform by turning a knob, the values of the
shifted points are calculated by interpolation. You can select either Linear or
Quadratic for the interpolating method.
Press the Interpolation side button to toggle between Linear or Quadratic.
When changes are made to the waveform by turning a knob, the shifted points
and the points in the nonshifted area are linked smoothly. This is called
smoothing. This parameter specifies the extent (of the nonshifted points) to
which smoothing applies. The value may be 0 to 1000.
1. Press the Smoothing side button.
2. Use the general purpose knob or numeric keys for value.
This specifies the center used for vertical scaling. The value may be –1.0 to 1.0.
1. Press the Vertical Origin side button.
2. Use the general purpose knob or numeric keys to change the value.
Moving the Cursor
During execution of Quick Edit, you can change the target area for editing, by
moving the cursors. When you use one of the four VERTICAL/HORIZONTAL
knobs; the general purpose knob and the numeric keys remain assigned to change
the value. To move a cursor, press the TOGGLE button on the front-panel before
operating the general purpose knob or numeric keys.
Follow the steps below to move the cursor:
1. Press the TOGGLE button on the front-panel to assign the general purpose
knob to cursor movement.
2. Set the cursor position using the general purpose knob or numeric keys.
Interpolating Method
Range of Smoothing
Position of Center of
Vertical Extent