Filter
Top Products
The Setup Menu Screen
3-32
AWG610 Arbitrary Waveform Generator User Manual
H There are too many lines in the sequence table. The maximum number of
lines is 8,000.
H There is more than one nesting level of subsequence files. The maximum
nesting level is one.
H The sequence calls itself.
H The destination of a line jump specified in the sequence table is greater
than the number of lines in the sequence table.
Equation Files. You cannot load an equation file (.equ) to output a signal. You
must first compile the equation file into a .wfm file prior to loading the wave-
form file.
This button lets you view a loaded waveform by pushing the View side menu
button. The instrument opens a window on the screen and displays the loaded
waveform. Push the OK side button to close the view window.
This button opens the appropriate editor for a loaded waveform, pattern, or
sequence file. Do the following steps to edit a loaded waveform or sequence file:
1. Push SETUP (front)!Waveform/Sequence (bottom)!Edit... (side).
The instrument opens the appropriate editor for the loaded waveform.
NOTE. The waveform and pattern editors have an output auto-update function
that can update the output waveform while you are editing the file. It has two
modes: Auto and Manual. Auto updates the waveform memory whenever there
are changes to the edit buffer. Manual updates waveform memory when you save
the file. To set the auto-update mode, push the Setting bottom menu button from
an editor screen.
The Vertical Menu
The Vertical menu lets you set waveform (analog and markers) vertical parame-
ters for all output channels. You can set signal peak-to-peak range, offset voltage,
and bandpass filter frequency. The Vertical menu commands are Filter, Ampli-
tude, Offset, Marker... and Output.
View
Edit...