Filter
Top Products
Groundsmaster 5900/5910 Page 3 -- 39 Diesel Engine
9. On Groundsmaster 5910 machines, install air condi-
tioning compressor to brackets (see Air Conditioning
Compressor Installation inthe Service and Repairs sec-
tion of Chapter 10 -- Operator Cab). Makesure that drive
belt is properly tensioned.
10.Using notes taken during engine removal, connect
wires and/or electricalconnections to the following elec-
trical components:
A. The alternator (Fig 32).
B. The temperature sensor on water pump housing
(Fig. 33).
C. Battery,frame and wireharnessground at the en-
gine block (Fig. 34).
IMPORTANT: When connecting wire harness to
engine electronic control module, make sure
that harness connector tab is aligned with corre-
sponding slot in control module.
D. The engine electronic control module.
E. The electric starter motor.
F. The air intake heater.
G. The air conditioning compressor (Groundsmas-
ter 5910 machines) (Fig. 35).
11.Install air cleaner assembly to the engine and intake
hoses to charge air cooler (see Air C leaner Installation
in this section). Make sure to torque hose clamps that
secure intake system hoses from 45 to 55 in--lb (5.1 to
6.2 N--m).
12.Install exhaustsystemtomachine(see ExhaustSys-
tem Installation in this section).
13.Connect coolant hoses to the radiator.Make sure ra-
diator drain is shut. Fill radiator and reservoir with cool-
ant.
14.Check position of electrical harnesses,fuel lines and
hydraulic hoses for proper clearance with rotating, high
temperature and moving components.
15.Connect positive battery cable first and then nega-
tive battery cable (see Battery Installation in the Service
and Repairs section of Chapter 5 -- Electrical System).
Secure batteries to machine with straps. Install access
panel.
16.Check and adjust engine oil as needed.
17.Check and adjust hydraulic oil as needed.
18.Bleed fuel system.
19.Run engine and check for any leaks.
20.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in the Service
and Repairs section of Chapter 4 -- Hydraulic System).
21.Install hood to machine (see Hood Installation in the
Service and Repairs section of Chapter 7 -- Chassis).
Diesel
Engine