Filter
Top Products
Groundsmaster 5910Operator Cab Page 9 -- 4
Air Conditioning Compressor
1. Flange head screw (4 used)
2. Pivot plate
3. Cap screw
4. Air conditioning compressor
5. Lock nut
6. Belt
7. Button head screw (2 used)
8. Flange head screw (3 used)
9. Mount plate
10. Flange nut (4 used)
11. Tensioner arm
12. Carriage screw (2 used)
13. Mount plate
14. Spacer (3 used)
15. Conduit
Figure 1
FRONT
RIGHT
11
2
1
3
12
4
7
8
6
10
9
5
10
10
12
13
14
15
34 to 42 ft--lb
(47to56N--m)
27 to 33 ft--lb
(37to44N--m)
27 to 33 ft--lb
(37to44N--m)
Removal (Fig. 1)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Raise hood to allow access to engine.
3. Loosen carriage screws and flange nuts that secure
A/Ccompressorandtensionerarm(Fig.2).Rotate com-
pressor to loosendrive belt. Removebelt from A/C com-
pressor pulley.
4. Inspectcompressor drive belt for glazingordamage.
Replace belt if necessary.
5. Disconnect compressor electrical connector from
machine wire harness.
6. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.