Filter
Top Products
Groundsmaster 5900/5910Page 5 -- 12Electrical System
Info Center controls for brightness and contrast can be
accessed by pressing and releasing the right button on
the Info Center (Fig. 9). Use the display buttons to
change the screen image and to exit the control screen.
Operator Advisories
Operator advisories are automatically displayed by the
Info Center when amachinefunction requires additional
action. For example, if the operator attempts to start the
engine when the traction pedal is depressed, an adviso-
ry is identified ontheInfoCenter Display that the traction
pedal needs to be in neutral. An advisory will not be
logged into any fault log.
Displayed advisories can be cleared from the display by
pressing any of the Info Center buttons.
Advisories are available for the following functions:
1. The TO START advisory identifies that the engine
starter will not engage after the ignition switch is turned
to START (Fig. 10):
A. ENGINE RUNNING. Engine is already running.
B. WAIT. Engine signalling wait due to air intake
heater being energized.
C. RESET TEACH PLUG. Traction pedal teach
wires are connected.
D. DISENGAGE PTO. The PTO switch is pulled out
(engaged) and must be disengaged before starter
will operate.
E. MOVE TP TO NEUTRAL. The traction pedal is
not in the neutral position.
F. SEAT OPERATOR OR SET PARKING BRAKE.
Operator needs to be in seat or parking brake needs
to be applied to engage starter.
1. Indicator bar
2. Menu
3. Brightness -- button
4. Brightness + button
5. Contrast -- button
6. Contrast + button
7. Exit button
Figure 9
1
73 4 5 6
2
Figure 10
A
B
C
D
E
F