Filter
Top Products
Groundsmaster 5900/5910 Page 5 -- 33 Electrical System
Fuses
The fuse blocks are located to the right of the operator
seat under the power center console.
Identification and Function (Figs. 57 and 58)
Fuse 1F1 (5 Amp) supplies power to ignition switch ter-
minal B.
Fuse 1F2 (30 Amp) supplies power to the starter sole-
noid circuit.
Fuse 1F3 (1 Amp)supplies power to theInfo Center Dis-
play.
Fuse 1F4 (30 Amp) supplies power to the Cummins En-
gine Controller.
Fuse 2F1 ( 15 Amp) supplies power to the road and
brake light circuits.
Fuse 2F2 (10 Amp) supplies power to the air ride seat
suspension seat compressor.
Fuse 2F3 (10 Amp) supplies power to the power point.
Fuse 2F4 (10 Amp) supplies power to the horn circuit.
Fuse 3F1 (2 Amp) supplies logic power for the
TEC--5002 Master Controller.
Fuse 3F2 (7.5 Amp) supplies power to the TEC--5002
Master Controller.
Fuse 3F3 (7.5 Amp) supplies power to the TEC--5002
Master Controller.
Fuse 3F4 (7.5 Amp) supplies power to the TEC--5002
Master Controller.
Fuse 4F1 (2 Amp) supplies logic power for the
TEC--5001 Slave Controller.
Fuse 4F2 (7.5 Amp) supplies power to the TEC--5001
Slave Controller.
Fuse 4F3 (7.5 Amp) supplies power to the TEC--5001
Slave Controller.
Fuse 4F4 (7.5 Amp) supplies power to the TEC--5001
Slave Controller.
Fuse Testing
1. Make sure that ignition switch is OFF and key is re-
moved from switch.
2. Remove power center cover from operator platform
to access fuses.
3. Remove fuse from fuse block for testing. Fuse
should have continuity across the terminals.
4. After fuse testing is completed, install and secure
power center cover.
Figure 57
Figure 58
4
3
2
1
4F
FRONT
5A
3F2F1F
30A
1A
30A
15A
10A
10A
10A
2A
7.5A
7.5A
7.5A
2A
7.5A
7.5A
7.5A
Electrical
System