Filter
Top Products
Groundsmaster 5900/5910Page 3 -- 36Diesel Engine
Engine
Figure 31
1. Engine assembly
2. Traction flush manifold
3. Cap screw (8 used)
4. Cap screw (4 used)
5. Rear engine mount (2 used)
6. Lock washer (4 used per mount)
7. Cap screw (4 used per mount)
8. Engine isolator mount (4 used)
9. Snubbing washer (4 used)
10. Lock nut (4 used)
11. Cap screw (4 used per mount)
12. Lock washer (4 used per mount)
13. Front LH engine mount
14. Front RH engine mount
15. Flange nut (8 used)
16. 4WD control manifold
FRONT
RIGHT
11
2
1
14
3
12
4
7
8
6
10
9
13
5
8
4
15
16
Engine Removal (Fig. 31)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Ifengineistobedisassembled,drainoilfromengine.
3. Remove hood (see Hood Removal in the Service
and Repairs section of Chapter 7 -- Chassis).
4. Remove battery access panel. Disconnect negative
battery cable first and then positive battery cable (see
Battery Removal in the Service and Repairs section of
Chapter 5 -- Electrical System).
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene--glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
5. Drain coolant from the radiator into a suitable con-
tainer (see Radiator Removal in this section). Discon-
nect coolant hoses from the radiator.