Filter
Top Products
Groundsmaster 5900/5910 Page 6 -- 5 Axles, Planetaries and Brakes
Wheel Removal (Fig. 1)
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen, but do not remove, lug nuts that secure
wheel to machine.
CAUTION
When changing attachments, tires or perform-
ing other service,use correct blocks, hoistsand
jacks to raise and support machine. Make sure
machine is parked on a solid level surface such
as a concrete floor. Prior to raising machine, re-
move any attachments that may interfere with
the safe and proper raising of the machine. Al-
ways chock or block wheels. Use appropriate
jack stands to support the raised machine.If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
4. Using a jack, raise machine so wheel to be removed
is off ground (see Jacking Instructions in Chapter 1 --
Safety). Support machine with appropriate jack stands.
5. Remove lug nuts and then remove wheel from ma-
chine.
Wheel Installation (Fig. 1)
NOTE: Thefrontwheels use eight(8) lug nuts. The rear
wheels use six (6) lug nuts.
1. Install wheel and secure with lug nuts.
2. Lower machine to ground.
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury.
WARNING
3. Torque wheel lug nuts evenly in a crossing pattern
from 70 to 90 ft--lb (95 to 122 N--m).
Axles, Planetaries
and Brakes