Filter
Top Products
Groundsmaster 5900/5910 Page 1 -- 5 Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service that requiresthemachine to be
raised,use correct jacks, hoistsandsupportsto
raise and support the machine. Make sure ma-
chineisparkedona solid level surface such asa
concrete floor. Prior to raising machine, remove
any attachments that may interferewith thesafe
and proper raising of the machine. Always
chock or block wheels. Use appropriate jack
stands to support the raised machine. If the ma-
chine is not properly supported by jack stands,
the machine may move or fall, which may result
in personal injury.
Jacking the Front End (Fig. 1)
1. Chock both r ear tires to prevent the machine from
moving.
2. Position jack securely under the frame, just to the in-
side of the front tire. Make sure that jack does not con-
tact hydraulic lift cylinder.
3. Position appropriate jack stands under the frame as
close to the front wheel as possible to s upport the ma-
chine.
Jacking the Rear End (Fig. 2)
1. Applyparking brake and chockboth front tires to pre-
vent the machine from moving.
2. Place jack securely under the center of rear axle.
Jack rear of machine off the ground.
3. Use appropriate jack stands under the rear axle to
support the machine.
1. Frame jacking point 2. Front tire
Figure 1
1
2
1. Rear axle jacking point 2. Rear tire
Figure 2
1
2
2
Safety