Filter
Top Products
Groundsmaster 5900/5910 Page 7 -- 17 Chassis
Disassembly (Fig. 14)
1. Park machine on a level surface, lower cutting units,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Remove two (2) cap screws (item 8) and then cover
plate (item 9) from outside of console arm. Locate and
retrieve two (2) flange spacers (item 28).
3. At front of console arm, remove screw (item 7) and
lock nut (item 2) that secure console arm covers to each
other.
4. Remove five (5) washer head screws (item 25) that
secure each cover to console arm panel.
5. Remove console arm covers from machine. As LH
cover (item 3) isremovedfrom console arm, unplug wire
harness connector from headlight switch.
6. Remove electrical components from console arm as
needed using Figure 14 as a guide.
7. If necessary, remove console panel and supports
from machine using Figures 14 and 15 as guides.
Assembly (Fig. 14)
1. Install all removed electrical and console arm com-
ponents using Figure 14 and 15 as guides.
2. Position covers to console arm. As LH cover (item 3)
is placed, plug wire harness connector to headlight
switch.
3. Secureeach cover to console armwith five (5) wash-
er head screws (item 25). Install screw (item 7) and lock
nut (item 2) to secure covers at front of console arm.
4. Position cover plate and flange spacers to outside of
console arm. Secure with two (2) cap screws.
1. Flat washer
2. Seat belt buckle
3. Coupling nut
4. Spacer
5. Carriage screw (5 used)
6. Lock washer
7. Cap screw
8. Arm support
9. Cap screw
10. Flange nut
11. Support channel
12. Flange nut (2 used)
13. Support bracket
14. Cap screw
15. Manual tube
16. R--clamp (2 used)
17. Screw (2 used)
Figure 15
2
3
6
7
5
4
8
9
10
1
11
12
13
10
1
5
14
15
16
17
Chassis