Filter
Top Products
Groundsmaster 5900/5910Cutting Decks Page 8 -- 2
Specifications
MOUNTING: Cutting decks are supported by lift arms
controlled with hydraulic lift cylinders.
CONSTRUCTION: Deck chambers are welded steel
construction reinforced with channels and plates.
HEIGHT--OF--CUT RANGE: 1” to 6” (25.4 mm to 152
mm) adjustable in 1/2” (12.7 mm) increments. Center
deck height--of --cut adjustmentis achieved by changing
spacers on castor wheels, re--positioning the castor
arms in the deck brackets, re--positioning the castor
wheel axles in the castor forks and adjusting length of
deck support chains. Wing deck adjustment is achieved
by changing spacers on castor wheels, re--positioning
the castor arms in the deck brackets and re--positioning
the castor wheel axles in the castor forks.
DECK DRIVE: Closed loop hydraulic system operates
hydraulic motor on each cutting deck. Motor drives one
spindle directly w ith remaining deck section spindle(s)
driven by B section kevlar v--belt(s). Blade spindles are
1--1/4” (31.7 mm) shafts supported by greaseable, ta-
pered roller bearings.
CUTTING BLADE: Cutting blade dimensions are 20”
(508 mm) long, 2.500” (64 mm) wide and 0.250” (6.4
mm) thick. Anti--scalp cup installed on each cutting
blade. Center deck includes five blades and each wing
deck includes three blades.
WIDTH OF CUT: Front deck provides 92” (2337 mm)
width of cut. Each w ing deck has 57” (1448 mm) width
of cut. Total width of cut is 192” (4877 mm).
DISCHARGE: Clippings are dischargedfromthe rear of
the cutting deck.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Front deck suspended
from lift arms and has two castor wheels, two adjustable
skids and three anti--scalp rollers. Wing decks sus-
pended from lift arms and have four castor wheels, two
adjustable skids and two anti--scalp rollers.