Filter
Top Products
Groundsmaster 5900/5910 Page 5 -- 11 Electrical System
Info Center Display
TheGroundsmasterInfoCenterDisplayisa LCD device
that is located on the steering tower. The Info Center
provides information for the machine operator during
machine operation, provides electrical system diagnos-
tic assistance for technicians and allows inputs for ad-
justable machine settings.
Power for the Info Center is available when the main
power relay is energized (ignition switch isin the START
or RUN position). Fuse 1F3 protects the Info Center
power circuit. A C AN bus system involving the
TEC--5001 controller, the TEC--5002 controller, the
Cummins ECM and the Info Center is used to provide
necessary machine communication for the Info Center.
NOTE: The TEC controllers and the Info Center Dis-
play used on the Groundsmaster 5900 and 5910 are
matched for correct machine operation. If any of these
components are replaced for any reason, system soft-
ware needs to be reprogrammed by your Toro Distribu-
tor.
Operator Information
The Info Center replaces traditional gauges by display-
ing engine and machine status. This information is dis-
played on two (2) screens that can be selected by the
operator.
Info Center Screen 1 (Fig. 6) is the default screen that
is displayed whenthe ignition switchis in either the RUN
or START position. Screen 1 displays engine coolant
temperature, fuel level, machine hours and whether the
tractionspeedisinLO or HIspeedrange.Indicator icons
will also appear on this screen when the PTO is en-
gaged, when the parking brake is applied, when the en-
gine cooling fan reverses direction, when the cruise
control is engaged, when the air intake heater is ener-
gized and when traction assist is engaged.
The Info Center navigation menu (Fig. 7) can be ac-
cessed by pressing and releasing any of the left four (4)
buttons on the display. The navigation menu will auto-
matically close after a short display time or it can be
closed by pressing the button under the opened door.
Info Center Screen 2 (Fig. 8) can be viewed by access-
ing the Info Center navigation menu and pressing the
button below SCREEN TWO. Screen 2 displays engine
RPM, hydraulic oil temperature, battery voltage and op-
erating time until the next service.
1. Coolant temperature
2. Fuel level
3. Machine hours
4. Traction speed
5. PTO icon
6. Parking brake icon
7. Cooling fan icon
8. Cruise icon
9. Intake heater icon
10. Traction assist icon
Figure 6
1
3
2
4
5
9
6
7
8
10
Figure 7
1
2 3 4 5
1. Navigation menu
2. Screen 1 access button
3. Screen 2 access button
4. Fault access button
5. Exit menu button
Figure 8
1
3
2
4
1. Engine RPM
2. Hydraulic oil temperature
3. Battery voltage
4. Time until next service
Electrical
System