Filter
Top Products
Groundsmaster 5900/5910Page 3 -- 16Diesel Engine
Radiator
Figure 14
1. Radiator assembly
2. Flange nut (4 used)
3. Support plate (2 used)
4. Flange nut (4 used)
5. Rubber pad (4 used)
6. Hose clamp (3 used)
7. Upper radiator hose
8. Overflow hose
9. Hose clamp
10. Worm clamp (5 used)
11. Barb fitting
12. Drain cock fitting
13. Fan shroud
14. Air intake tube (4 used)
15. Hose clamp (8 used)
16. Tube
17. Coolant reservoir
18. Grommet (2 used)
19. Lock nut (2 used)
20. Hose
21. Cap screw (4 used)
22. Hose
23. Radiator cap
24. Support rod
25. Flat washer (10 used)
26. Flange nut (4 used)
27. Hose sleeve
28. Cap screw (2 used)
29. Tube
30. Washer (4 used)
31. Flange nut (14 used)
32. Clamp (2 used)
33. Carriage screw (14 used)
34. Lower radiator hose
35. Fan motor bracket
36. Fitting
37. Coolant l evel sensor
38. Cap screw (2 used)
39. Reservoir cap
40. Flat washer (2 used)
FRONT
RIGHT
11
2
1
14
3
12
4
7
8
6
10
9
13
5
15
16
17
18
19
20
21
22
23
26
27
24
25
28
29
31
34
35
32
33
36
37
39
38
6
14
31
31
33
10
40
25
33
25
31
25
26
2
30
50 to 70 in--lb
(5.7 to 7.9 N--m)
50 to 70 in--lb
(5.7 to 7.9 N--m)
15
Thread Sealant
Removal (Fig. 14)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Raise and support hood to allow access to radiator.
3. Rotate clamps that secure oil cooler to radiator
frame. Tilt oil cooler toward rear of machine.
4. Loosen hose clamps and disconnect air intake tubes
(item14) from the charge air cooler.
5. Disconnectwire harness connector from coolant lev-
el sensor on right side of radiator.