Filter
Top Products
Groundsmaster 5900/5910Page 5 -- 22Electrical System
7. TRACTION ASSIST (Fig. 33)
NOTE: Traction assist only engages when low
speed range is selected and the traction pedal is
pressed in the forward direction.
To engage forward traction assist, the following in-
puts have to be initiated:
D Traction assist switch depressed to engage trac-
tion ass ist (TRACTION ASSIST INPUT ON)
D Seat needs to be occupied (SEAT ON)
D Hi--Lo speed switch needs to be in LO (HIGH
RANGE OFF)
If the listed inputs exist, the following output should
occur:
D Traction assist will be engaged (TRACTION AS-
SIST OUTPUT ON)
8. CRUISE CONTROL (Fig. 34)
To engage cruise control, the following inputs have
to be initiated:
D Cruisecontrol switch in the ON position(CRUISE
ON/OFF ON)
D Cruisecontrolswitchdepressed toengagecruise
control (CRUISE ENGAGE ON)
If the listed inputs exist, the following output should
occur:
D Cruisecontrol will be engaged (CRUISE ACTIVE
ON)
9. ENGINE RUN (Fig. 35)
When the ignition switch is in the ON position, the
ENGINE RUN Diagnostic screen should show:
D KEY RUN input ON
D OK RUN output ON
To allow the engine to start, the following inputs have
to be initiated:
D Ignitionswitch needs to be turned to START(KEY
START and KEY RUN both ON)
D PTO disengaged (PTO ENABLED OFF)
D Traction pedal not in TEACH mode (TEACH EN-
ABLED OFF)
D Traction pedal in neutral (NEUTRAL FORWARD
and NEUTRAL REVERSE both OFF)
D Seat occupied or parking brake applied (either
SEAT ON or PARKING BRAKE ON)
If the listed inputs exist, the following outputs should
occur:
D The engine starter motor should engage (OK
RUN and START both ON)
Figure 33
Figure 34
Figure 35