Filter
Top Products
Groundsmaster 5900/5910Page 5 -- 16Electrical System
12.The TO SET RANGE HIGH advisory identifies that
high speed rangewill not engage whenthe Hi--Lo s peed
switch is pressed (Fig. 21).
A. LIFT LEFT DECK. Left cutting deck is lowered
and needs to be raised before high speed range can
be engaged.
B. LIFT LEFT DECK FULLY. Left cutting deckis low-
ered below the up limit switch and needs to be raised
before high speed range can be engaged.
C. LIFT CENTER DECK. Center (front) cutting deck
is lowered and needs to be raised before high speed
range can be engaged.
D. LIFT CENTER DECK FULLY. Center (front) c ut-
ting deck is lowered below the up limit switch and
needs to be raised before high speed range can be
engaged.
E. LIFT RIGHT DECK.Right cutting deck is lowered
and needs to be raised before high speed range can
be engaged.
F. LIFT RIGHT DECK FULLY. Right cutting deck is
lowered below the up limit switch and needs to be
raised before high speed range can be engaged.
G. DISENGAGE PTO. PTO is engaged and must be
shut off before high speed range can be engaged.
H. DISENGAGE CRUISE. Cruise control is en-
gaged and must be shut off before high speed range
can be engaged.
I. REDUCE GROUND SPEED. Ground speed
needs to be less than 2 MPH in order to engage high
speed range.
Figure 21
A
B
C
E
G
I
D
F
H