Filter
Top Products
Reelmaster 2300–D/2600–DHydraulic System Page 4 – 54
2WD/3WD Two Position Valve
1. Two position valve
2. Nut
3. Cap screw
4. Tub clamp
5. Hydraulic tube
6. Hydraulic connection
7. Hydraulic connection
8. Hydraulic connection
9. Hydraulic connection
10. Hydraulic fitting
11. Hydraulic fitting
12. Hydraulic fitting
13. O–ring
14. Cap screw
15. O–ring
Figure 51
SKIRT ASSEMBLY
5
3
6
13
5
15
15
12
13
9
15
11
13
8
7
10
13
1
14
2
4
Removal (Fig. 51)
1. Before removing any parts from the hydraulic man-
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
CAUTION
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
2. Clean two position valve (1) and hydraulic fittings.
3. Put caps or plugs on any hydraulic lines or fittings
left open or exposed. Put labels on disconnected hy-
draulic lines and hoses for proper reassembly.
4. Loosen nut (2) and cap screw (3) so the tubes
clamps (4) will allow movement of the hydraulic tubes
(5).
5. Disconnect hydraulic connections (6, 7, 8 and 9)
from hydraulic fittings (10, 11, and 12). Allow hydraulic
oil to drain from tubes into a suitable container.
6. Remove cap screws (14) from two position valve
(1).
7. Remove fittings (10, 11, and 12) and O–rings (15)
from two position valve (1).
Installation (Fig. 51)
1. Install hydraulic fittings (10, 11, and 12) and O–rings
(15) into two position valve (1).
2. Secure cap screws (14) to two position valve (1)
through the skirt assembly.
3. Install hydraulic connections (6, 7, 8 and 9) to hy-
draulic fittings (10, 11, and 12) and tighten fittings.
4. Tighten nut (2) and cap screw (3) so the tube clamps
(4) will prevent movement of the hydraulic tubes (5).