Filter
Top Products
Reelmaster 2300–D/2600–DPage 7 – 2Cutting Units
Specifications
Figure 1
MOUNTING: All cutting units are supported by equal
length independent lift arms and are interchangeable to
all three cutting unit positions.
REEL CONSTRUCTION: 5 or 8 blades of 7” (18 cm) di-
ameter welded to 5 stamped steel spiders. Reels are
mounted on greaseable self–aligning ball bearings. The
RM2300–D reel is 27 inches long and the RM2600–D
reel is 32 inches long.
HEIGHT OF CUT RANGE:
Floating Cutting Unit – 1/4” to 1–3/4”
(6.4mm to 44.4mm)
Fixed Cutting Unit – 1/2” to 2–5/8”
(12.7 mm to 65.6 mm)
POWER: Reel motors allow easy removal from or instal-
lation onto the cutting unit. Cutting units can be driven
from either end.
HEIGHT–OF–CUT & ROLLER ADJUSTMENT:
Height–of–cut adjustment is made with the rear roller by
a quick locating pin and/or threaded micro–adjustment.
Front roller position is adjustable to 3 locations to set cut-
ting unit attitude.
BEDKNIFE AND BEDBAR ADJUSTMENT: A single
knob screw adjustment for bedknife to reel is located at
the center of the bedbar. The adjustment knob detent al-
lows 0.001 inch bedknife movement for each indexed
position.
CLIP FREQUENCY: With variable speed set to maxi-
mum rpm:
5 blade at 880 reel rpm moving 4 mph (6.4 km/h)
.96” (24.4 mm) clip.
5 blade at 880 reel rpm moving 5 mph (8 km/h)
1.19” (30.3 mm) clip.
8 blade at 880 reel rpm moving 4 mph (6.4 km/h)
.60” (15.2 mm) clip.
8 blade at 880 reel rpm moving 5 mph (8 km/h)
.75” (19.1 mm) clip.
RM2300–D OPTIONAL EQUIPMENT:
Full Roller Kit Model No. 03440
Sectional Roller Kit Model No. 03445
Wiehle Roller Kit Model No. 03450
Anti–Scalp Roller Kit Model No. 03447
Grass Basket Kit Model No. 03443
Roller Scraper Kit Part No. 60–9560
Comb Kit Part No. 67–9400
Fixed Kit Part No. 93–6915
Skid Kit Part No. 94–3664
RM2600–D OPTIONAL EQUIPMENT:
Sectional Roller Kit Model No. 03476
Wiehle Roller Kit Model No. 03475
Anti–Scalp Roller Kit Model No. 03477
Roller Scraper Kit Model No. 03478
Fixed Kit Part No. 93–6915
Skid Kit Part No. 94–3664
CUTTING UNIT LIFT: Hydraulic lift has an automatic
reel shut off. All units are controlled from one lever.
SUSPENSION SYSTEM: Adjustable counterbalance
spring provide for a fully floating suspension. L–I–N–
K–ST cutting unit suspension system provides fore and
aft oscillation. Main center pivot allows side–to–side os-
cillation. With optional Fixed Kit (Part No. 93–6915), cut-
ting units can be locked into fixed (fore/aft) position for
use with skids or anti–scalp rollers.