Filter
Top Products
Reelmaster 2300–D/2600–DPage 7 – 10Cutting Units
Height–of–Cut and Front Roller Level
1. On gauge bar, set head of screw to desired Height–
of–Cut. This measurement is from bar face to underside
of screw head. Gauge bar (Toro Part No. 13–8199) may
be obtained from your local Toro Distributor.
2. Slightly loosen (crack) nuts securing each front roll-
er bracket to the angle bracket.
3. Place the bar across the front and rear rollers and
adjust both front roller support capscrews until the un-
derside of the head of screw on the gauge bar engages
the bedknife cutting edge. Do this on both ends of reel.
4. Tighten all nuts securing the roller brackets.
Figure 10
1. Gauge bar
2. Front roller bracket nut
3. Front roller bracket
4. Angle bracket
5. Front roller support cap
screw
6. Bedknife
1
3
4
6
5
2