Filter
Top Products
Reelmaster 2300–D/2600–D
Page 5 – 20
Electrical System
Indicator Lights and Circuits
Note: Individual light bulbs can be tested by removing
them from the lighting cluster and applying 12 VDC to
their wiring terminals.
Oil Pressure Light
The oil pressure light should come on when the ignition
switch is in the ON position with the engine not running.
Also, it should light with the engine running when the oil
pressure drops below 4 PSI (0.3 kg/cm
2
).
1. Disconnect the brown wire from the oil pressure
switch.
2. Ground the brown wire to the engine block.
3. Turn the ignition switch to ON; the light should come
on.
4. Turn the ignition switch to OFF and connect the
brown wire to the oil pressure switch.
High Temperature (Water) Shutdown Light
The temperature light should come on only if the high
temperature shutdown switch and relay have stopped
the engine when the coolant temperature is above
206_F (97_C). The ignition switch must be in either the
ON or START position for the light to come on.
1. Disconnect the tan wire from the high temperature
shutdown switch.
2. Ground the tan wire to the engine block.
3. Turn the ignition switch to ON; the light should come
on and the high temperature shutdown relay should
click.
4. Turn the ignition switch to OFF and connect the tan
wire to the high temperature shutdown switch.
Glow Light
The glow light should come on with the ignition in the
GLOW or START position.
1. Turn the ignition switch to GLOW or START; the light
should come on.
2. Turn the ignition switch to OFF.
Battery Light
The battery light should come on when the ignition
switch is in ON with the engine not running or with an im-
properly operating charging circuit while the engine is
running.
1. Turn ignition switch to ON; the light should come on.
2. Turn ignition switch to OFF.
Figure 9
OIL
(RED)
BATT
(AMBER)
WATER
(RED)
GLOW
(AMBER)
1
2
5
6
123456
FRONT
BACK
Figure 10
GLOW
BATT
OIL
WATER
2
5
6
1
3
4