Filter
Top Products
Reelmaster 3100−DHydraulic System (Rev. C)
Page 4 − 50
12.Make sure backlap knob on the hydraulic manifold is
in the backlap position.
13.One person should sit on the seat and operate the
machine while another person reads the gauge. Start
engine and move the throttle to full speed (2650 +
50
RPM).
CAUTION
Keep away from reels during test to prevent per-
sonal injury from the rotating reel blades.
CAUTION
Do not allow system pressure to exceed 1800
PSI. Shut off unit to prevent an over pressure
condition.
14.Engage cutting units. System pressure should be
from 1350 to 1650 PSI as the relief valve lifts.
15.Disengage cutting units and stop engine. If specifica-
tions are not met, the cross−over relief needs replacing.
Remove block of wood from cutting unit and repeat test
on other reels in the same direction of flow.
16.Remove test gauge and reconnect hose to motor.
Adjust bedknife to reel on all cutting units (see Adjust-
ment section of Chapter 7 − Cutting Units).