Filter
Top Products
Reelmaster 3100−DPage 7 − 10Cutting Units
Verify Height−of−Cut and Front Roller Level
NOTE: Gauge bar (Toro Part No. 13−8199) may be ob-
tained from your local Toro Distributor.
IMPORTANT: Height−of−cut must be set and both
rollers leveled before performing this adjustment
(see Set Height−of−Cut and Level Both Rollers).
1. On the gauge bar, set head of the screw to the de-
sired Height−of−Cut. This measurement is from the bar
face to the underside of the screw head.
2. Loosen nuts slightly that secure each front roller
bracket to the angle bracket.
3. Place gauge bar across the front and rear rollers. Ad-
just both front roller support capscrews until the under-
side of the head of screw on the gauge bar engages the
bedknife cutting edge. Do this on both ends of reel.
4. Tighten all nuts securing the roller brackets.
5. Place cutting unit on a flat surface. Verify that front
and rear rollers contact the flat surface. Readjust
Height−of−Cut as required (see Set Height−of−Cut and
Level Rear Roller).
Figure 9
1. Gauge bar
2. Front roller bracket nut
3. Front roller bracket
4. Angle bracket
5. Front roller support ca
p
screw
6. Bedknife
1
3
4
6
5
2