Filter
Top Products
Reelmaster 3100−D
Page 2 − 10
Product Records and Maintenance
Preparation for Seasonal Storage
Traction Unit
1. Clean traction unit, cutting units, and the engine thor-
oughly.
2. Check tire pressure. Inflate all tires to 14 to 18 psi
(0.97 to 1.24 Bar).
3. Check all fasteners for looseness; tighten as neces-
sary.
4. Lubricate all grease fittings and pivot points (see Lu-
brication).
5. Cover entire length of the Sidewinder (Model 03201)
cross tube with a light oil to prevent rust. After storage,
wipe off all oil.
6. Lightly sand and use touch−up paint on painted
areas that are scratched, chipped, or rusted. Repair any
dents in the metal body.
7. Service battery and cables as follows:
A. Remove battery terminals from the battery posts
(see Battery Service in Chapter 5 − Electrical Sys-
tem).
B. Clean battery, terminals, and posts with a wire
brush and baking soda solution.
C. Coat cable terminals and battery posts with Grafo
112X skin−over grease (Toro Part No. 505-47) or pe-
troleum jelly to prevent corrosion.
D. Every 30 days, check battery electrolyte levels
and fill battery as necessary (see Battery Care in
Chapter 5 − Electrical System).
E. Every 60 days, recharge battery slowly for 24
hours to prevent sulfate from forming on the battery
plates (see manufacturer’s instructions for battery
charger).
Traction Unit
1. Drain engine oil from the oil pan and replace the drain
plug.
2. Remove and discard oil filter. Install a new oil filter.
3. Refill oil pan with approximately 4.0 quarts (3.8 l) of
SAE10W-30 motor oil.
4. Start engine and run at idle speed for approximately
two minutes.
5. Stop engine.
6. Drain all fuel thoroughly from the fuel tank, fuel lines,
and water/fuel separator (see Water/Fuel Separator
and Fuel System in Chapter 3 − Kubota Diesel Engine).
7. Flush the fuel tank with fresh, clean diesel fuel (see
Fuel System in Chapter 3 − Kubota Diesel Engine).
8. Re−secure all fuel system fittings.
9. Clean and service the air cleaner assembly (see Ser-
vice Air Filter, Dust Cup, and Burp Valve in Chapter 3 −
Kubota Diesel Engine).
10.Seal air cleaner inlet and the exhaust outlet with
weatherproof tape.
11.Check anti−freeze protection and add as needed for
expected minimum temperature in your area (see
Check Cooling System in Chapter 3 − Kubota Diesel En-
gine).