Filter
Top Products
Reelmaster 3100−D Hydraulic System (Rev. C)
Page 4 − 103
Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove hydraulic cylinder from the frame using Fig-
ure 68 as guide.
2. If hydraulic fittings are to be removed from cylinder,
mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed, install fittings to
cylinder using marks made during the removal process
to properly orientate fittings.
2. Install hydraulic cylinder to the frame using Figure 68
as guide.
3. Adjust scissors mount as follows:
A. Shift sidewinder fully to the left (fully retract cylin-
der).
B. Loosen four cap screws securing mount to lower
frame.
C. The gap between the scissor frame and lower
frame and the gap between the scissor frame and
the sidewinder carrier must be equal distances with-
in 0.060 inch (1.5 mm).
D. Tighten four cap screws and lock nuts.
1. Scissor frame
2. Lower frame
3. Sidewinder carrier
4. Gaps
Figure 69
2
1
3
4
Hydraulic
System