Filter
Top Products
Reelmaster 3100--D
DPA Cutting Units (Rev G)
Page 8 -- 18
Bedbar Assembly
1. Bedbar
2. Bedknife
3. Screw
4. Bedbar adjuster shaft (2 used)
5. Flange bushing (4 used)
6. Cap screw (2 used)
7. Detent (2 used)
8. Wave washer (2 used)
9. Retaining ring (2 used)
10. Bedbar adjuster screw (2 used)
11. Washer (2 used)
12. Compression spring (2 used)
13. Lock nut (2 used)
14. Rubber bushing (2 used)
15. Flange bushing (2 used)
16. Plastic washer (4 used)
17. Metal washer (2 used)
18. Bedbar pivot bolt (2 used)
19. Lock nut (2 used)
Figure 19
Antiseize
Lubricant
27 to 33 ft--lb
(37to44N--m)
FRONT
RIGHT
6
7
8
9
10
11
12
13
15
16
17
18
19
14
4
5
2
5
3
16
1
Antiseize
Lubricant
Bedbar Removal (Fig. 19)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools).
3. Loosen the lock nuts (item 13) on the end of each
bedbar adjuster assembly until washer (item 11) is
loose.
4. Loosen the lock nuts (item 19) on each bedbar pivot
bolt (item 18).
5. Remove two ( 2) bedbar pivot bolts (item 18), two (2)
metal washers (item 17) and four (4) plastic washers
(item 16) from the cutting unit side plates.