Filter
Top Products
Reelmaster 3100−D Page 7 − 25 Cutting Units
Fixed Side Plate Installation
1. Remove pop rivets and rear height−of−cut plates
from both sides of the cutting unit (Fig. 30).
2. Remove lock nuts, capscrews, washers, and both
links from the cutting unit (Fig. 30).
3. Align fixed side plate with holes on the cutting unit
(Fig. 31).
4. Attach new capscrews, washers, and flanged lock
nuts to the fixed side plate and the cutting unit (Fig. 31).
5. Tighten lock nuts and capscrews.
6. Fasten new height−of−cut plate to the cutting unit
with new pop rivets (Fig. 31).
7. Repeat steps 1 through 6 on the other side of the cut-
ting unit.
1. Pop rivet
2. Height−of−cut plate
3. Lock nut
4. Capscrew
5. Washer
6. Link
4
6
1
2
5
3
Figure 30
1. Fixed side plate
2. Capscrews
3. Washers
4. Flanged lock nut
5. Height−of−cut plate
6. Pop rivet
1
5
6
3
2
4
Figure 31
Cutting Units