Filter
Top Products
Reelmaster 3100−D Page 7 − 19 Cutting Units
Bedbar Installation (Fig. 23)
1. Inspect flanged bushings and bushing for wear; re-
place if necessary.
2. Clean and apply anti−seize lubricant to both bedbar
pivots. Install bedbar washer on the bedbar.
3. Install bedbar adjusting housing and bedbar housing
on the bed bar. Reinstall spacer, flat washer, lock wash-
er, and cap screw on the bedbar.
4. Install bedbar assembly on the cutting unit.
5. Secure bedbar housing to the cutting unit with both
carriage bolts and nuts.
6. Secure adjusting housing to the cutting unit with both
carriage bolts and nuts (Fig. 24).
7. Tighten both adjusting lock nuts on the adjusting
housing (Fig. 24).
8. Position bedbar fitting to the bedbar yoke. Screw ad-
justing handle (left−hand threaded) until the bedbar fit-
ting is snug against the bedbar yoke.
1. Adjusting lock nut
2. Adjusting housing
3. Carriage bolt and nut
3
2
1
Figure 24
9. Adjust bedknife to reel (see Bedknife to Parallel to
Reel Adjustment).
Cutting Units