Filter
Top Products
Reelmaster 3100−D Hydraulic System (Rev. C)
Page 4 − 115
Removal
1. Remove front lift cylinder from the frame and lift arm
using Figure 80 as guide.
2. If hydraulic fittings are to be removed from lift cylin-
der, mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed, install fittings to
cylinder using marks made during the removal process
to properly orientate fittings.
IMPORTANT: With lift arms raised fully, hydraulic
hoses should be routed as shown in Figure 81. Make
sure clearance between hydraulic hose and lift arm
is from 0.040 to 0.120 inches (1.0 to 3.0 mm).
2. Install front lift cylinder to the frame and lift arm using
Figure 80 as guide.
3. Adjust front lift arm (see Adjust Front Lift Arm in
Chapter 7 − Cutting Units).
1. Lift cylinder
2. Hydraulic hoses
3. Clearance
Figure 81
1
3
2
Hydraulic
System