Filter
Top Products
Reelmaster 3100−DHydraulic System (Rev. C)
Page 4 − 56
Adjustments
Adjust Traction Drive for Neutral
1. Park the machine on a level surface and turn the en-
gine off.
One front wheel and
rear wheel must be raised
off the ground or the machine will move during
adjustment. Make sure machine is supported
so it will not accidentally fall injuring anyone
under machine.
WARNING
2. Raise one front wheel and rear wheel off floor and
place support blocks under frame.
3. Loosen locknut on traction adjustment cam.
Engine must be running so final adjustment of
the traction adjustment cam can be performed.
To guard against possible personal injury,
keep hands, feet, face and other parts of the
body away from the muffler, other hot parts of
the engine, and other rotating parts.
WARNING
4. Start engine and rotate cam hex in both directions to
determine mid position of neutral span.
5. Tighten locknut securing adjustment.
6. Stop engine.
7. Remove support blocks and lower the machine to
the shop floor. Test drive the machine to make sure it
does not creep.
1. Adjustment cam 2. Lock nut
Figure 33
1
2