Filter
Top Products
Reelmaster 3100−D Hydraulic System (Rev. C)
Page 4 − 113
IMPORTANT: Do not dislodge seals during installa-
tion.
12.Install wear plate into the gear pocket of back body
with the pressure seal and back−up gasket against the
adapter plate. Make sure mid section cut−away of the
wear plate is on the suction side of the pump.
13.Lubricate back gear with clean hydraulic oil. Install
gear onto the drive gear shaft and key.
14.Lubricate back idler gear with clean hydraulic oil.
Install idler gear into the gear pocket of back body and
the adapter plate.
15.Install new O−ring into the groove of the back plate.
16.Align marker line on the back plate and body. Install
back plate onto the body and gear shafts.
17.Secure pump together with cap screws and new
washers on cap screws external of the flange cavity.
Torque cap screws in a criss−cross pattern from 25 to 28
ft−lb (34 to 38 N−m).
Hydraulic
System