Filter
Top Products
Reelmaster 3100−DHydraulic System (Rev. C)
Page 4 − 60
Replace Hydraulic Oil Filter
The hydraulic system filter must be changed initially, af-
ter the first 10 hours of operation, and thereafter every
200 hours of operation or yearly, whichever comes first.
The hydraulic oil must be changed every 400 hours of
operation or yearly, whichever comes first.
Use a genuine Toro oil filter for replacement.
IMPORTANT: Use of any other filter may void the
warranty on some components.
1. Position machine on a level surface, lower the cut-
ting units, stop the engine, engage the parking brake
and remove key from ignition switch.
2. Clamp hose leading to the oil filter head from the hy-
draulic tank to prevent draining the hydraulic tank.
3. Clean area around filter mounting surface. Place
drain pan under filter and remove filter. Properly dispose
of filter.
4. Lubricate new filter gasket and fill the filter with hy-
draulic fluid.
5. Assure filter mounting area is clean. Screw filter on
until gasket contacts mounting plate. Then tighten filter
one−half turn.
1. Hydraulic oil filter 2. Rear wheel
Figure 38
1
2
6. Remove clamp from hydraulic hose. Check and ad-
just hydraulic oil level in hydraulic tank.
7. Start engine and let run for about two minutes to
purge air from the system. Stop the engine and check for
leaks.
8. Check level of fluid and add enough to raise level to
FULL mark on dipstick. DO NOT OVER FILL.