Filter
Top Products
Rev. B
Reelmaster 5010 SeriesPage 1 -- 4Safety
Jacking Instructions
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock
or block wheels. Use jack stands or other ap-
propriate load holding devices to support the
raised machine. If the machine is not properly
supported, the machine may move or fall,
which may result in personal injury.
CAUTION
Front End Jacking (Fig. 1)
1. Apply parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Positionjack securely underthe frameaxle tube, just
to the ins ide of the front wheel.
3. Jack front of machine off the gr ound.
4. Position jack stands under the frame as close to the
wheel as possible to support the machine.
Rear E nd Jacking (Fig. 2)
1. Apply parkingbrake andchock both front tires topre-
vent the machine from moving.
2. Place jack securely at the center of the rear axle un-
der the axle pivot br acket. Jack rear of machine off the
ground.
3. Position jack stands under the frame to support the
machine.
Figure 1
1. Front wheel 2. Front jacking point
1
2
Figure 2
1. Axle center 2. Jack stand location
2
1
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the tractionunit andthecuttingunitsof yourReelmaster.
If any decal becomes illegible or damaged, install a new
decal. Part numbers for decals are listed in your Part
Catalogs. Order replacement decals from your Autho-
rized Toro Distributor.