Filter
Top Products
Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 70
4. Carefully lower pump assembly to machine frame.
5. Secure pump assembly to machine frame with two
(2) flange screws and flange nuts.
6. Secure pump support bracket to inside of frame
bracket with two (2) carriage screws (item 38) and
flange nuts (item 36).
7. Install hydraulic hoses to fittings on pump assembly
in positions noted during removal.
8. Connect machine harness electrical connector to
traction neutral switch.
9. Position traction control cable to traction pump lever
and secure plate(item 10) to pump lever with capscrew
and locknut.Secure cablebracket totraction pumpwith
two (2) flange head screws.
10.Install hydraulic pump drive shaft (see Hydraulic
Pump Drive Shaft Installation in this section).
11.Checkoil level in hydraulic reservoir andadd correct
oil if necessary.
12.Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
13.Check traction drive for neutral and traction neutral
switch operation. Adjust if necessary.