Filter
Top Products
Reelmaster 5010 SeriesPage 6 -- 24Chassis (Rev C)
Rear Lift Arms
1. Spacer (2 used)
2. #2 lift arm
3. #3 lift arm
4. Washer (2 used per chain hoop)
5. Spring catch
6. Flange head screw (2 used)
7. Cap screw (2 used)
8. Flat washer (2 used)
9. Pivot pin (2 used)
10. Washer head screw (1 used per pin)
11. Pivot yoke (2 used)
12. Lynch pin (2 used)
13. Thrust washer (2 used per yoke)
14. Spacer (2 used)
15. Grease fitting (2 used)
16. Snapper pin (1 used per yoke)
17. Cap (1 used per yoke)
18. Chain hoop (2 used)
19. Lock nut (2 used)
20. Cap screw (2 used per chain hoop)
21. Flange nut (2 used per chain hoop)
22. Chain (2 used)
23. RH torsion spring
24. LH torsion spring
25. Washer (2 used)
26. Flange bushing (2 used per arm)
27. Bushing (2 used per yoke)
28. Grease fitting (1 used per yoke)
29. Flange bushing (2 used per arm)
30. Cylinder pin (2 used)
31. Thrust washer (2 used per pin)
32. Retaining ring (2 used per pin)
Figure 21
FRONT
RIGHT
17
28
27
20
16
13
18
21
13
3
15
9
10
2
12
22
4
25
1
23
5
6
14
8
7
19
15
24
11
26
13
12
26
27
29
29
29
31
32
30
31
32
Removal (Fig. 21)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Removecutting unit from rearlift armto beremoved.
3. Remove one retaining ring (item 32) and thrust
washer (item 31) from the cylinder pin (item 30) that se-
cures the lift cylinder rod end to lift arm. Pull cylinder pin
fromtheliftcylinderand liftarm.Locateandretrievesec-
ond thrust washer.
4. Pivot lift cylinder rod end away from lift arm.
CAUTION
Be careful when removing tension from the tor-
sion springonthe rearlift arms.The springis un-
der heavy load and may cause personal injury.
5. Removetensionfromtorsionspringonrearofliftarm
pivot pin.
A. Insert nut driver or small piece of pipe onto the
endof thetorsionspringthat issecuredon therear of
the lift arm pivot pin.