Filter
Top Products
Reelmaster 5010 Series Hydraulic System (Rev. C)Page 4 -- 93
6. Put caps or plugs on disconnected lines and fittings
to prevent contamination.
7. Support manifold to prevent it from falling. Remove
three( 3) capscrews andlock washersthat secureman-
ifold to machine frame. Locate and retrieve three (3)
spacers from between bracket and manifold.
8. Remove AWD manifold from machine.
9. Ifnecessary,removehydraulicfittingsfrommanifold.
Discard any removed O--rings.
Installation (Fig. 79)
1. If fittings were removed from AWD manifold, lubri-
cate andplacenew O--r ings tofittings. Installfittings into
manifold (seeHydraulic FittingInstallation in theGener-
al Information section of this chapter).
2. Position manifold and three (3) spacers to frame
bracket. Install three (3) lock washers and cap screws
but do not fully tighten.
3. Remove caps and plugs from disconnected lines
and fittings.
4. Lubricate and install new O--ring(s) on manifold fit-
tings. Connect hydraulic lines to hydraulic manifold fit-
tings. Properly tighten all connections (see Hydraulic
Fitting Installation in the General Information section).
5. Secure AWD manifold to frame by tightening three
(3) cap screws.
6. Check oillevel in hydraulic reservoirand add correct
oil if necessary.
7. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
Hydraulic
System