Filter
Top Products
Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 92
CrossTrax
TM
AWD (Optional Kit) Manifold
1. AWD manifold
2. Hydraulic tube
3. Hydraulic tube
4. Hydraulic tube
5. O--ring
6. Hydraulic fitting (7 used)
7. O--ring
8. Dust cap (2 used)
9. Diagnostic fitting (2 used)
10. O--ring
11. Cap screw (3 used)
12. Lock washer (3 used)
13. Spacer (3 used)
14. Hydraulic hose (4 used)
15. Frame bracket
Figure 79
FRONT
RIGHT
4
3
1
2
9
10
11
8
5
6
7
12
13
14
15
Removal (Fig. 79)
1. Parkthe machineona levelsurface, engageparking
brake, lower cutting units and stopengine. Remove key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Locate CrossTrax
TM
AWD manifold that is attached
to bracket at rear of frame.
4. Label all hydraulic connections for assembly pur-
poses. Thoroughly clean hydraulic connections prior to
loosening hydraulic lines.
CAUTION
Before openinghydraulic system, operateall hy-
draulic controls to relieve system pressure and
avoid injury from pressurized hydraulic oil. See
Relieving HydraulicSystemPressure inthe Gen-
eral Information section of this chapter.
5. Disconnecthydraulichosesandtubes fromfittingsin
manifold. Allow lines to drain into a s uitable container.
Remove and discard O --rings.