Filter
Top Products
Reelmaster 5010 Series Hydraulic System (Rev. C)Page 4 -- 97
CAUTION
Before openinghydraulic system, operateall hy-
draulic controls to relieve system pressure and
avoid injury from pressurized hydraulic oil. See
Relieving HydraulicSystemPressure inthe Gen-
eral Information section of this chapter.
4. Disconnect hydraulic hoses from fittings in reel mo-
tor.Allowlinestodrainintoasuitablecontainer.Remove
and discard O--rings.
5. Putcaps orplugs ondisconnectedhoses andfittings
to prevent contamination.
6. Remove reel motor from cutting unit (see Hydraulic
Reel Motor Removal in theService and Repairs section
of Chapter 7 -- Cutting Units).
7. If hydraulic fittings are to be removed from motor,
mark fitting orientation to allow correct assembly. Re-
move fittings from motor and discard O --rings.
Installation (Fig. 81)
1. If hydraulic fittings were removed from motor, lubri-
cate new O--rings, position O--rings to fittings and install
fittingsintomotorports(seeHydraulic FittingInstallation
intheGeneral Informationsectionofthischapter).Make
sure that fittings are orientated correctly.
2. Install reel motor to cutting unit (see Hydraulic Reel
Motor Installation in the Service and Repairs section of
Chapter 7 -- Cutting Units).
3. Remove caps or plugs from fittings and hoses.
IMPORTANT: When installing the hydraulic hoses,
makesure thathydraulichosesares traight (nottwisted)
before tightening the hoses to the motor fittings.
4. Lubricate and install new O--rings on motor fittings.
Correctly connecthydraulic hoses tothe motorusing la-
bels placed during removal procedure.
5. Check oillevel in hydraulic reservoirand add correct
oil if necessary.
6. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
Hydraulic
System