Filter
Top Products
Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 40
Relief Valve (R1) and (R2) Pressure Test
Figure 37
FORWARD
M7
M6
R8
REARMOWCIRCUIT
FRONTMOWCIRCUIT
R9
100MESH
SUCTION
STRAINER
INTERNAL
CASE
DRAIN
TRACTION
WHEEL
MOTORS
P1
P2
P3 P4
G5
G6
G2
EP2
MSV2
MSV1
OR2
OR4
MR2
FC2
CV
EP1
G1
OR3
FC1
OR1
MR1
P2
T
P1
M1
BKLP1
M2
BKLP2
B
R2
R1
R5
R4
R3
A
B
A
B
LH
RH
EXTERNALCASEDRAIN
A
R11
C.U.5C.U.1C.U.4
R11
R11R11
C.U.3
C.U.2
R11
M4
M1
M5
M2
M3
P5
FROMLIFT CONTROLMANIFOLD
TOLIFTCONTROLMANIFOLD
TOSTEERING CONTROLVALVEAND CHARGE CIRCUIT
TESTER
FROMSTEERING CONTROLVALVE
RELIEF VALVE (R1)
TEST SHOWN
MOW
CONTROL
MANIFOLD
The relief valve (R1) and (R2) pressure test should be
performed to make sure thatthe cutting unit circuit relief
pressures are correct.
NOTE: Thefrontcutting unitcircuitis protectedbyrelief
valve(R2).Therearcuttingunitcircuitis protectedbyre-
lief valve (R1) (see Hydraulic Flow Diagrams in this
chapter).
Procedure for Relief Valve (R1) and (R2) Pressure
Test
1. Make sure hydraulic oil is at normal operating tem-
perature by operating the machine under load for
approximately ten (10) minutes.
2. Parkmachine ona levelsurfacewiththecuttingunits
loweredand PTOs witch off.Make sureengine isoffand
mow/transport lever is in mow. Apply the parking brake.
3. Read Precautions For Hydraulic Testing in this sec-
tion.