Toro 4043 Greenhouse Kit User Manual


 
Greensmaster eFlex 1800/2100Page 4 -- 36Electrical System
EZ Turn Switch
TheEZturnswitchallowstheEZturnfeaturetobe
turned on and off. This switch is one of several inputs for
theTECcontroller.TheEZturnswitchislocatedonthe
control panel (Fig. 44).
NOTE: TheEZturnfunctionisonlyactivewhenthema-
chine is being operated with the cutting unit engaged.
Also, the EZ turn switch and EZ turn sensor are in series
so both switch and sensor have to be ON for the EZ Turn
function being ON. If either the switch or the sensor is
OFF,theEZTurnfunctionwillbeOFF.
EZ turn switch operation can be checked with the Info-
Center on the console. With the key switch in the RUN
position and the InfoCenter in the Diagnostics menu,
choose EZ Turn and make sure that the switch state
changes as the switch is toggled between ON and OFF.
Further EZ turn switch testing is necessary only if the
switch state does not change when using the InfoCent-
er.
Switch Testing
1. Park machine on level surface and place traction le-
ver in the NEUTRAL position. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Lithium Battery Pack Con-
nection in the General Information section of this
chapter).
2. Remove console cover from handle to allow access
to EZ turn switch (Fig. 44). Disconnect EZ turn switch
connector from the machine wire harness.
3. The EZ turn switch terminals are marked as shown
in Figure 45. The circuitry of the switch is shown in Fig-
ure 46. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
switch position. Verify continuity between switch termi-
nals.
4. Replace EZ turn switch if necessary.
5. Connect switch to machine wire harness. Secure
console cover to handle.
6. Connect the battery pack (see Lithium Battery Pack
Connection in the General Information section of this
chapter).
Figure 44
5
3
1
2
4
1. EZ turn switch
2. Switch panel
3. Lower handle
4. Console cover
5. Screw (4 used)
FRONT
RIGHT
Figure 45
12
4
3
56
SWITCH
POSITION
NORMAL
CIRCUITS
OTHER
CIRCUITS
OFF 1+2 4+5
ON 2+3 5+6
Figure 46