Filter
Top Products
Greensmaster eFlex 1800/2100Page 4 -- 34Electrical System
Reel Engage Switch
1. Reel engage switch
2. Engagement lever assembly
3. Lower handle
4. Washer head screw (2 used)
5. Lock nut (2 used)
6. Console cover
7. Washer head screw (4 used)
8. Switch mount bracket
Figure 42
FRONT
RIGHT
5
3
1
2
6
4
7
8
The reel engage switch is a normally open proximity
switch. This switch is one of several inputs for the TEC
controller. The switch is attached to the handle assem-
bly switch mount bracket (Fig. 43).
When the cutting reel is not engaged, the tab on the cut-
ting reel engagement lever is positioned away from the
target end of the reel engage switch so the switch re-
mains open. The tab on the reel lever is moved next to
the switch when the cutting reel is engaged causing the
switch to close.
CheckTractionSwitchOperation
Reel engage switch operation can be checked with the
InfoCenter on the console. With the key switch in the
RUN position and the InfoCenter in the Diagnostics
menu, choose Reel Enable and make sure that the
switch state changes as the cutting reel is engaged and
released. Further reel engage switch testing is necessa-
ry only if the switch state does not change when using
the InfoCenter.