Filter
Top Products
Greensmaster eFlex 1800/2100Groomer Page 7 -- 10
Grooming Reel (Forward Rotating Groomer Drive)
Figure 8
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. RH drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. LH support plate assembly
15. LH groomer arm assembly
16. HOC washer (2 used)
17. RH cutting unit side plate
18. LH cutting unit side plate
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. O--ring
FRONT
RIGHT
Antiseize
Lubricant
100 ft--lb
(135 N--m)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
20
21
22
23
24
11
12
13
25
17 to 21 ft--lb
(24 to 28 N--m)
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft (if not equipped with carbide blades)
or to replace the grooming shaft.
Removal (Fig. 8)
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Make
sure the traction lever is in the NEUTRAL position.
2. Disconnect the battery pack (see Battery Pack Con-
nection in the General Information section of this chap-
ter).
3. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
4. Remove groomer drive cover (item 2) and groomer
drive b elt (item 3) from groomer drive (see Groomer Belt
Replacement in this section).
5. Loosen cap screws (item 10) that secure front roller
shaft to groomer arms.
6. Remove lock nut (item 13) and spring washer (item
12) that secure RH groomer arm lift rod to drive plate as-
sembly (Fig. 9).