Filter
Top Products
Greensmaster eFlex 1800/2100 Page 6 -- 3 Cutting Unit
Specifications
REEL CONSTRUCTION: 5--inch (12.7 cm) diameter,
11 or 14 carbon steel blades welded to 5 stamped steel
spiders. High strength low alloy steel blades are thru
hardened and impact resistant.
FRAME CONSTRUCTION: Precision machined die
cast aluminum cross member with two bolt--on die--cast
aluminum side plates.
HEIGHT--OF--CUT: Cutting height is adjusted on the
front roller by t wo vertical screws and held by two lock
nuts. Standard bench height of cut range is 0.062 to
0.500 inch (1.6 to 12.7 mm) depending on type of bed-
knife installed. An optional High Height of CutKit is avail-
able for higher HOC adjustments. Effective HOC may
vary depending on turf conditions, type of bedknife, roll-
ers and attachments installed.
CLIP: Clip frequency is adjusted by moving the pulleys
on the cuttingunit reel drive housing.6--clip adjustments
are possible based on pulley configuration.
ROLLERS: The rear roller is a 2.000” (5.1 cm) diameter
aluminum full roller. The front roller is a 2.500” (6.3 cm)
diameter roller that ischosenfrom a variety ofconfigura-
tions (narrow spaced Wiehle front roller is shown
above).
BEDKNIFE AND BEDBAR: Single edged Edgemax
TM
bedknife (solid tool steel construction) used with 11 and
14 blade c utting unit. A cast iron bedbar is fastened to
the cutting unit. Other optional bedknives and a less
aggressive bedbar are available.
GRASS SHIELD: Non--adjustable shield with adjusta-
ble cut--off bar to improve grass discharge from reel in
wet conditions.
COUNTERBALANCE WEIGHT: A cast iron weight
mounted on right end of cutting unit balances the cutting
unit.
APPROXIMATE WEIGHT:
eFlex 1800 with11 Blade Reel 69 lb (31.3 kg)
eFlex 1800 with14 Blade Reel 71 lb (32.2 kg)
eFlex 2100 with 11 Blade Reel 71 lb (32.2 kg)
eFlex 2100 with 14 Blade Reel 73 lb (33.1 kg)
NOTE: Approximate weights listed do not include front
roller or cutting unit options (e.g. rear roller brush or
groomer).
Cutting Unit