Filter
Top Products
Greensmaster eFlex 1800/2100 Page 6 -- 7 Cutting Unit
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers (Fig. 9).
Seal installation washer: 107--8133
Seal installation spacer: 107--3505
Bearing installation washer: 104--6126
As an alternative to using washers and spacers listed
above, a special tool set is available that can be used for
roller bearing and seal installation (Fig. 10).
Toro Part Number: TOR4105
Figure 9
Seal Installation
Washer
Seal Installation Bearing Installation
WasherSpacer
(yellow)(black)
Figure 10
Diameter/Circumference Measuring Tape
Toro Part Number: TOR6023
Spring steel measuring tape for accurately measuring
the circumference and outside diameter of cutting r eel
and other spherical components. Tape calibration is in
fixed inch readings (no adjustments).
Figure 11
Turf Evaluator Tool
Toro Model Number: 04399
Many turf discrepancies are subtle and require closer
examination. In these instances, the Turf Evaluator
grass viewing tool is helpful. It can assist turf managers
and service technicians in determining causes for poor
reel mower performance and in comparing the effective
height--of--cut of one mowed surface to another. This
tool should be used with the Toro Guide to Evaluation
Reel Mower Performance and Using the Turf Evaluator
(Toro part no. 97931SL).
Figure 12
Cutting Unit