Filter
Top Products
Greensmaster eFlex 1800/2100Traction and Reel Drive System Page 3 -- 6
Special Tools
Modified Socket for Reel Clutch Bearing Collar
The modified socket is used to remove and install the
reel clutch bearing collar when servicing the transmis-
sion reel clutch shaft (Fig. 5). Refer to Transmission
Reel Drive System in the Service and Repairs section of
this chapter for complete information on servicing the
reel clutch shaft assembly.
Socket Modification
1. Make sure that socket (9/16” or 15mm) to be modi-
fied fits over the reel clutch shaft bearing collar.
2. Drill a hole or grind slots in socket walls to allow a
5/32” pin to extend through socket. A modified socket
with ground slots is shown in Figure 6.
Modified Socket Use (Fig. 7)
IMPORTANT: To prevent damage, avoid using ex-
cessive clamping pressure on the reel clutch shaft
assembly.
1. Use flats on reel drive hub to carefully secure reel
clutch shaft assembly in a vise. Use a vise with soft jaws
to prevent damage to clutch shaft assembly compo-
nents.
2. Slide modified socket over bearing collar.
3. Align modified socket so that 5/32” pin can be in-
serted through socket and hole in bearing collar.
4. Use modified socket and socket wrench to loosen or
tighten bearing collar.
Figure 5
1. Bearing collar
2. Reel clutch shaft
3. Hub flat location
123
Figure 6
1. Modified socket
2. Reel clutch shaft assy
3. Pin
Figure 7
3
2
1